Titan U glossary

Debris Flow

A debris flow is a fast-moving landslide in which water-soaked mud, rock, boulders and trees travel downslope or down a channel as one flowing mass. The U.S. Geological Survey (USGS) describes debris flows as particularly dangerous to life and property because they move quickly, destroy what lies in their path and often strike without warning.

A debris flow is a fast-moving landslide in which water-soaked mud, rock, boulders and trees travel downslope or down a channel as one flowing mass. The U.S. Geological Survey (USGS) describes debris flows as particularly dangerous to life and property because they move quickly, destroy what lies in their path and often strike without warning.

How it differs from a flood or a mudflow

A debris flow carries so much solid material that it behaves differently from floodwater. The USGS says it can move boulders, trees and cars, and if it enters a steep stream channel it can travel for several miles, reaching areas unaware of the hazard.

In everyday speech these events are often called mudslides or mudflows, and the USGS notes that usage. The National Weather Service (NWS) office in Missoula points out that scientists treat each as a different kind of landslide, with debris flows the most powerful and dangerous of the three.

The American Meteorological Society (AMS) Glossary describes a mudflow as a dense, highly viscous mass of mostly fine-grained material.

What triggers one

The USGS says debris flows generally occur during periods of intense rainfall or rapid snowmelt and usually start on hillsides or mountains.

Recently burned slopes are especially susceptible, and so are the areas downslope of a burn. NWS Missoula notes that a flow can start on a dry slope after only a few minutes of intense rain.

How fast they move

The USGS says debris flows can travel at speeds up to and exceeding 35 mph (56 km/h). NWS Missoula puts it more simply: they can travel faster than a person can run.

What the rain total does not tell you

Thresholds are site-specific. NWS Missoula cites about half an inch of rain in less than an hour as a general rule of thumb for flash flooding in a burn area, but the slope, soil and age of the burn all change the answer.

Risk also changes over time. The USGS notes that post-fire debris flows can occur in the years right after a fire, and that some develop over longer periods as roots decay and the soil loses strength.

Keep going

How Debris Flow connects

Builds on 2

  • Burn Scar

    Recently burned slopes, and the land below them, are especially prone to debris flows, which can occur in the years right after a fire.

  • Rainfall Rate

    Debris flows usually start during intense rainfall, and a few minutes of hard rain on a burned slope can be enough.

Leads to 1

  • Flash Flood Watch

    The Flash Flood Watch can be issued for debris flow threats from heavy rain on burned or landslide prone slopes, so debris flows are part of what it warns about.

Contrasts with 2

  • Flash Flood

    Debris flows and flash floods are set off by the same intense rain, but a debris flow carries far more solid material and can travel miles down a channel.

  • Burn Scar Flooding

    Burn scar flooding is floodwater carrying mud and debris, while a debris flow carries so much solid material that it behaves differently, and burned slopes can produce both.