Titan U glossary

Near-Surface Smoke

Near-surface smoke is a model forecast of how much wildfire smoke is in the air just above the ground, about 8 meters (roughly 26 feet) up. NOAA's High-Resolution Rapid Refresh (HRRR) smoke model, HRRR-Smoke, produces it alongside vertically integrated smoke, which totals the smoke through the whole column.

Near-surface smoke is a model forecast of how much wildfire smoke is in the air just above the ground, about 8 meters (roughly 26 feet) up. NOAA's High-Resolution Rapid Refresh (HRRR) smoke model, HRRR-Smoke, produces it alongside vertically integrated smoke, which totals the smoke through the whole column.

How the model builds it

HRRR-Smoke locates fires using fire radiative power, a satellite estimate of the heat a fire releases. It then forecasts how much smoke each fire produces, how high the plume rises and how the smoke spreads through the lower and middle atmosphere.

The near-surface field samples the lowest part of that three-dimensional forecast. NCEP's HRRR file inventory lists it as a mass density at 8 meters above ground, so it describes the mass of smoke in each cubic meter of air.

Why forecasters watch it

NOAA describes near-surface smoke as the smoke very close to the ground, where it can create unsafe air quality, aggravate health problems such as asthma and limit visibility. A NOAA fact sheet describes the field as a forecast of fire-emitted fine particulate matter, the particle class tracked as PM2.5.

Comparing it with the vertically integrated field shows whether a smoke event is mainly overhead or down at the surface. Heavy column smoke with light near-surface values points to smoke aloft and hazy skies rather than poor air at the ground.

How the daily cycle changes it

Near a fire, smoke often behaves differently by time of day. An NWS Albuquerque aviation briefing notes that early morning smoke is trapped at low elevations under a temperature inversion and drains into valleys, then begins to loft into a plume once the inversion breaks.

That cycle is why surface smoke near a fire can be heaviest in the early morning, especially in valleys.

Limits and what comes next

The forecast depends on its fire inputs. If satellites miss a fire or misjudge its heat, the smoke source in the model is off, so check near-surface forecasts against air quality monitors.

The Rapid Refresh Forecast System (RRFS) is scheduled to begin NWS operations in October 2026. NOAA calls its built-in smoke and dust component, RRFS-SD, the next generation of HRRR-Smoke, and says the HRRR will remain in operations alongside RRFS.

Keep going

How Near-Surface Smoke connects

Builds on 2

  • Fire Radiative Power

    The near-surface smoke forecast builds on fire radiative power, which HRRR-Smoke uses to locate fires and their smoke sources.

  • Temperature Inversion

    Near-surface smoke builds on temperature inversions, which trap morning smoke low until the inversion breaks and the smoke lofts.

Part of 1

  • High-Resolution Rapid Refresh

    Near-surface smoke is a field from HRRR-Smoke, the smoke version of the HRRR model, produced alongside vertically integrated smoke.

Contrasts with 2

  • Vertically Integrated Smoke

    Near-surface smoke shows smoke just above the ground, while vertically integrated smoke totals the whole column, so comparing them shows smoke aloft versus at the surface.

  • Smoke Plume

    A smoke plume on a satellite map can be well above the ground, so near-surface smoke forecasts and monitors are the better guide to the air people breathe.

Appears here 1

  • Fine Particulate Matter

    Smoke PM2.5 is forecast in the near-surface smoke field, which NOAA describes as fire-emitted fine particulate matter near the ground.