Titan U glossary

Precipitable WaterPWAT

Precipitable water (PWAT) is the depth of liquid water that would result if all of the water vapor in a vertical column of the atmosphere condensed and fell as rain, usually reported in inches or millimeters.

Precipitable water (PWAT) is the depth of liquid water that would result if all of the water vapor in a vertical column of the atmosphere condensed and fell as rain, usually reported in inches or millimeters.

What the column measurement captures

PWAT is computed by integrating the mixing ratio through the depth of the atmosphere above a location. A column with a shallow but very moist surface layer and a dry middle troposphere can carry the same PWAT as a column with modest moisture spread through a much deeper layer, so the single number hides the vertical distribution.

Because it is a bulk quantity, PWAT is well suited to comparisons. Forecasters compare the current PWAT at a site against the climatological mean and standard deviation for that date. Values well above the local climatology, particularly above the 90th percentile, are often flagged as a heavy rainfall or flash flood signal.

How forecasters use it

For severe weather, PWAT gives a quick read of moisture available to storms and how much rain a slow-moving cell could produce. A rich column supports high rainfall rates when storms fire and can favor water-loaded downdrafts. A dry column tends to produce more evaporation of falling precipitation and stronger, cooler outflows.

For heavy rain and flash flood forecasting, PWAT is one of the ingredients in the ingredients-based method used by NWS forecasters. It is paired with storm motion, warm cloud depth, and instability to judge whether repeated cells over the same area could bring enough rain to threaten flooding.

Important limits

A high PWAT does not tell you where or when it will rain. Lift, forcing, and storm mode still decide whether the moisture is tapped. Values well above normal with no lift can sit for a day producing only isolated showers.

PWAT also does not describe rainfall efficiency. Two storms in the same PWAT environment can produce very different totals depending on their motion, their depth, and whether entrainment of drier air aloft reduces how much of the column moisture actually reaches the ground.

Keep going

How Precipitable Water connects

Builds on 1

  • Mixing Ratio

    Precipitable water is built from mixing ratio, adding up the moisture at every level through the column above a location.

Leads to 2

  • Rainfall Rate

    A moisture-rich column, shown by high precipitable water, can support high rainfall rates when storms form.

  • Training Storms

    Judging how much rain training storms can drop builds on precipitable water, which helps estimate how much water each repeated pass may deliver.

Contrasts with 3

  • Precipitation Efficiency

    Precipitable water says how much water is in the column, while precipitation efficiency is about how much of it a storm actually turns into rain.

  • Dewpoint

    Dewpoint describes moisture at one level, usually the surface, while precipitable water sums the moisture through the whole column.

  • Moisture Transport

    Moisture transport is a flux that tells you what is arriving, while precipitable water is the moisture already sitting in the column.