Titan U glossary

Runoff

Runoff is the part of rain or snowmelt that does not stay where it falls and instead reaches stream channels, either by flowing over the ground or by moving through the soil. Surface runoff is the share that travels across the land surface.

Runoff is the part of rain or snowmelt that does not stay where it falls and instead reaches stream channels, either by flowing over the ground or by moving through the soil. Surface runoff is the share that travels across the land surface.

Two routes to the stream

Surface runoff travels overland into the channel, and rain that falls directly on the stream is often counted with it. Water that soaks in can still reach the stream through the ground.

Interflow, also called subsurface stormflow, moves toward the channel below the surface, faster than baseflow but usually slower than surface runoff. Baseflow is the slow contribution from water that infiltrated and eventually worked through the soil to the stream.

The U.S. Geological Survey (USGS) notes that in forested watersheds a large share of the rain soaks into soils, is stored as groundwater and is released slowly to streams through seeps and springs.

When water runs off the surface

Infiltration excess runoff happens when rain or snowmelt arrives faster than the soil can take it in. COMET Program training ties it most often to short, intense rain and to clay soils or ground altered by compaction, urbanization or fire.

Saturation excess runoff happens when the soil is already full and no more water can soak in. It is most common with long-duration, gentle to moderate rain, especially in humid climates with gently sloped or flat basins.

How forecasters estimate it

River Forecast Centers (RFCs) run rainfall-runoff models for each basin. The Arkansas-Red Basin RFC lists land slope, urbanization, soil types, the amount of the last rain, the time since it fell and evaporation as the main inputs.

One model it describes, the Sacramento model, works out total runoff from the interaction of two soil zones. The output is then routed downstream and turned into a river forecast.

What the number leaves out

A runoff estimate covers volume, not timing. When the water arrives depends on the size, shape and slope of the watershed, which shows up on a hydrograph at a gauge.

Pavement shifts the balance quickly. The National Severe Storms Laboratory (NSSL) notes that buildings, highways, driveways and parking lots increase runoff by reducing how much rain the ground absorbs, which is why cities can flood on rain that a rural area would mostly soak up.

Keep going

How Runoff connects

Builds on 3

  • Soil Infiltration

    Runoff often starts when rain arrives faster than the soil can take it in, so infiltration sets how much water is left over to run off.

  • Soil Saturation

    When the soil is already full, more rain cannot soak in and becomes runoff, which happens most often with long spells of gentle to moderate rain.

  • Watershed

    How much water runs off is only half the story, since the size, shape and slope of the watershed decide when it arrives.

Leads to 2

  • Urban Flooding

    Pavement and roofs keep rain from soaking in, so urban flooding builds on runoff that reaches drains and creeks far faster than on open ground.

  • Rain-on-Snow Event

    A rain-on-snow event can produce runoff from the rain and from melting snow at the same time, more than the rain alone would give.

Contrasts with 1

  • Rainfall Accumulation

    A rainfall total is not the same as runoff, because soil, ground cover and wetness decide how much of the rain reaches a stream.

Seen in 1

  • Hydrograph

    Runoff reaching a channel shows up as the rising limb of a hydrograph at the gauge downstream.