Titan U glossary

Three-Body Scatter SpikeTBSS

A three-body scatter spike (TBSS), also called a hail spike, is a radar artifact caused by large hail, typically severe hail. It shows up as a narrow streak of weak echo extending straight away from the radar, on the far side of a very intense storm core.

A three-body scatter spike (TBSS), also called a hail spike, is a radar artifact caused by large hail, typically severe hail. It shows up as a narrow streak of weak echo extending straight away from the radar, on the far side of a very intense storm core.

How it forms

Part of the beam's energy that hits large hail scatters straight back to the radar. Some scatters down to the ground, back up to the hail and then back to the radar, three trips in all.

That detour takes longer, so the radar places the returned energy farther out along the same line of sight. The result is false echo where there is no storm.

What it looks like

The spike lines up along a radial behind the core, usually with weak reflectivity below about 20 dBZ, and at moderate display thresholds it is often under about 9 miles (15 km) long. Velocity in the spike tends to be near zero or weakly toward the radar.

At ranges under about 75 miles (120 km) it usually appears on midlevel scans, where large hail grows. On correlation coefficient it can stand out as a low-value streak.

How forecasters use it

A 1998 study of 10 cm (S-band) WSR-88D radar data found the spike behind cores stronger than about 63 dBZ and tied it to hail of 1 inch (2.5 cm) or larger. It advised forecasters to anticipate that hail that size may reach the ground within about 10 to 30 minutes.

National Weather Service (NWS) offices note that a spike almost always means the storm contains large hail. With a pronounced spike, the same study advised anticipating hail larger than 2 inches (5 cm).

What it does not tell you

A spike is sufficient but not necessary. Its absence does not rule out large hail, and the spike does not give a stone size by itself.

Because it is false echo, it should never be read as precipitation. In one National Severe Storms Laboratory (NSSL) testbed case, spikes in supercell inflow regions complicated automated rotation detections.

Keep going

How Three-Body Scatter Spike connects

Part of 1

  • Radar Artifact

    A three-body scatter spike is a radar artifact, a false echo lined up behind a hail core, so it should never be read as precipitation.

Seen in 3

  • Radar Reflectivity

    A three-body scatter spike appears in reflectivity as a weak streak lined up along a radial behind an intense core.

  • Correlation Coefficient

    A three-body scatter spike can stand out on correlation coefficient as a low-value streak behind the hail core.

  • Radial Velocity

    In radial velocity, a three-body scatter spike tends to show values near zero or weakly toward the radar.

Appears here 1

  • Hail

    Large hail can show up on radar as a three-body scatter spike, a false streak behind the core, but the spike is sufficient rather than necessary, so many hail storms never show one.