Titan U glossary

Wet Microburst

A wet microburst is a microburst that arrives with heavy rain at the ground. A strong downdraft inside a rain shaft hits the surface and spreads out, producing a small, short-lived burst of damaging wind under and around the heaviest rain.

A wet microburst is a microburst that arrives with heavy rain at the ground. A strong downdraft inside a rain shaft hits the surface and spreads out, producing a small, short-lived burst of damaging wind under and around the heaviest rain.

How it fits with other downbursts

Downburst is the umbrella term for localized strong winds caused by a thunderstorm downdraft. The American Meteorological Society (AMS) Glossary defines a microburst as covering an area less than about 2.5 miles (4 km) along a side, with peak winds lasting 2 to 5 minutes, and notes microbursts can be wet or dry.

The National Severe Storms Laboratory (NSSL) notes microburst winds sometimes exceed 100 mph. What separates the wet type from a dry microburst is what reaches the ground: heavy precipitation with the wet type, little or none with the dry type.

What drives the downdraft

The National Weather Service (NWS) office in Nashville lists precipitation loading, the weight of water held in the cloud, as one primary cause of wet microbursts. Melting ice inside the storm can add to the downward push.

Evaporation plays a smaller role than in a dry microburst. The Nashville office notes the dry layer in southeastern US wet microburst environments is typically shallower, so evaporative cooling adds less. Where mid-level winds are strong, the sinking air can also carry that faster wind down toward the ground.

Signals forecasters watch

The NWS office in Louisville describes wet microburst environments as unstable and moist near the ground, with steep low-level lapse rates and weak vertical wind shear. Its tip sheet also lists a surface-to-minimum-aloft difference in equivalent potential temperature (theta-e) of 20 degrees or more, a sign of dry air sitting over moist air.

On radar, a Louisville training paper points to a high reflectivity core that starts higher than in other storms and then descends rapidly, often with convergence at mid-levels in storm-relative velocity data.

In the field, and what it hides

The NWS Advanced Spotters' Field Guide notes that a small, intense, globular rain area with lighter rain in its wake may mark a wet microburst. A rain foot, an outward bulge at the edge of the rain shaft near the ground, is another visual cue.

As the outflow spreads from the impact point, it may raise a plume of dust that the same guide calls a dust foot.

The rain that defines a wet microburst also hides it, so the strongest wind is often inside the rain shaft. The sounding guides above come from one office and flag a favorable environment, not a specific storm, so radar trends carry the short-term call.

Keep going

How Wet Microburst connects

Builds on 1

  • Precipitation Loading

    Precipitation loading, the weight of water held in the cloud, is one primary cause of wet microbursts.

Part of 1

  • Microburst

    A wet microburst is the kind of microburst that arrives with heavy rain at the ground.

Contrasts with 1

  • Dry Microburst

    A dry microburst reaches the ground with little or no rain, while a wet microburst arrives inside heavy rain.

Measured by 1

  • Equivalent Potential Temperature

    Some forecasters screen wet microburst setups with the theta-e drop from the surface to a minimum aloft, a sign of dry air sitting over moist air.

Seen in 2

  • Radar Reflectivity

    In reflectivity a wet microburst often starts as a high core that sits higher than in other storms and then drops rapidly.

  • Storm-Relative Velocity

    Storm-relative velocity can show mid-level convergence above a wet microburst's rapidly descending core.